E.200 – Dewatering press for cans and plastic bottles

Level sensors in the feed hopper enable the press to operate automatically. As soon as a defined material level is reached, the machine starts up automatically. If the level falls below a specified minimum, the system automatically switches to standby mode to prevent unnecessary wear and tear on the components.

The angled discharge chute allows the moulded products to be ejected at a higher angle, enabling them to fall directly into a large container or a tipping trough. This eliminates the need for an additional conveyor belt. Depending on the space requirements, the discharge chute is available in a straight version or with an angle to the left or right.

Thanks to their lockable castors, the E-series machines can be positioned flexibly during operation. This ensures optimal access for maintenance and cleaning work. In addition, an integrated maintenance and cleaning flap on the hopper provides easy and direct access to the interior of the machine.

The key components of the hydraulic unit have been deliberately oversized to ensure that sufficient power reserves are available even under full load. Among other things, this reduces heat build-up during operation whilst also increasing the machine’s resistance to contaminants.

Our focus is on maximum durability. That is why all machines in the E-Series are made from high-quality stainless steel. This ensures high durability, reduces maintenance requirements and, at the same time, meets the hygiene standards of sensitive production environments.

For particularly flexible use in the workplace, the compact E-Series presses are fitted with braked castors and can be easily moved to the required location. Once there, they can be put into operation immediately. Thanks to their IP65-rated design, they can also be used outdoors on a temporary basis if required.

The drip tray integrated beneath the press reliably collects any liquids that escape during the pressing process. Depending on the installation layout, these liquids can be channelled directly into a floor drain or pumped out or diverted via a hose fitted with a milk pipe coupling.

The curved feed hopper ensures that cans or other materials cannot escape from the machine during the pressing process due to the high pressing forces. At the same time, the curved design facilitates easy cleaning and reduces the risk of squeezed-out liquids spurting uncontrollably from the feed opening. The E.200 is also available with two alternative hopper designs.

Parameters such as pressing time and pressing force can be adjusted quickly and intuitively via the colour display of the integrated PLC control system. The post-pressing function can also be set with ease. The programmable holding time is particularly important when pressing absorbent materials, as it ensures adequate drainage and produces moulded parts that retain their shape over time.

To compensate for temperature fluctuations in the hydraulic oil, the E-series machines are equipped with a water-cooling system based on the heat exchanger principle. This ensures consistent operating conditions and enables long running times without breakdowns. The heat exchanger is integrated into the hydraulic housing, where it is protected and reliably shielded from contamination.